1262P ATTEST water vapor, cycles other than FLASH, reading after 48 hours

175.23 

Safety Data Sheet
Copyright,2015,3M Company.
All rights reserved. Copying and/or downloading of this information for the purpose of properly utilizing 3M products is allowed provided that: (1) the information is copied in full with no changes unless prior written agreement is obtained from 3M, and (2) neither the copy nor the original is resold or otherwise distributed with the intention of earning a profit thereon.
Document group: 11-2863-6 Version number: 5.00
Issue Date: 09/09/2015 Supersedes date: 02/07/2012
This Safety Data Sheet has been prepared in accordance with the Preparation of Safety Data Sheets for Hazardous Chemicals
Code of Practice (Safe Work Australia, December 2011)
SECTION 1: Identification
1.1. Product identifier
3M™ Attest™ Biological Indicators for Steam 1261, 1261P, 1262, 1262P & 1262-S
Product Identification Numbers
70-2005-0348-3 70-2005-0349-1 70-2005-0440-8 70-2005-0441-6
1.2. Recommended use and restrictions on use
Recommended use
Sterilization process indicator, To indicate attainment of conditions for sterilization.
For Industrial or Professional use only.
1.3. Supplier’s details
Address: 3M Australia – Building A, 1 Rivett Road, North Ryde NSW 2113
Telephone: 136 136
E Mail: productinfo.au@mmm.com
Website: www.3m.com.au
1.4. Emergency telephone number
EMERGENCY: 1800 097 146 (Australia only)
SECTION 2: Hazard identification
This product is NOT classified as a hazardous chemical according to the Model Work Health and Safety Regulations, 2011.
This product is an article and is not regulated by the Model Work Health and Safety Regulations (2011) because, it is not classified as hazardous. When used as recommended or under ordinary conditions, it should not present a health and safety hazard. However, use or processing of the product not in accordance with the product’s recommendations or not under ordinary conditions may affect the performance of the product and may present potential health and safety hazards.
Refer to Section 14 of this Safety Data Sheets for product Dangerous Goods Classification.
2.1. Classification of the substance or mixture Not applicable.
2.2. Label elements
Signal word
Not applicable.
Symbols
Not applicable.
Pictograms
Not applicable.
2.3. Other assigned/identified product hazards None known.
2.4. Other hazards which do not result in classification None known.
SECTION 3: Composition/information on ingredients
This material is a mixture.
Ingredient CAS Nbr % by Weight
Plastic vial and cap Unknown 40 – 55
Growth media containing carbohydrates, amino acids, bromcresol purple None 30 – 40
Glass ampule None 15 – 30
Spore strip with geobacillus
stearothermophilus (previously bacillus stearothermophilus) None < 1 SECTION 4: First aid measures 4.1. Description of first aid measures Inhalation No need for first aid is anticipated. Skin contact No need for first aid is anticipated. Eye contact No need for first aid is anticipated. If swallowed No need for first aid is anticipated. 4.2. Most important symptoms and effects, both acute and delayed See Section 11.1. Information on toxicological effects. 4.3. Indication of any immediate medical attention and special treatment required Not applicable SECTION 5: Fire-fighting measures 5.1. Suitable extinguishing media Material will not burn. 5.2. Special hazards arising from the substance or mixture None inherent in this product. 5.3. Special protective actions for fire-fighters No special protective actions for fire-fighters are anticipated. SECTION 6: Accidental release measures 6.1. Personal precautions, protective equipment and emergency procedures Not applicable. 6.2. Environmental precautions Not applicable. 6.3. Methods and material for containment and cleaning up Not applicable. SECTION 7: Handling and storage 7.1. Precautions for safe handling This product is considered to be an article which does not release or otherwise result in exposure to a hazardous chemical under normal use conditions. 7.2. Conditions for safe storage including any incompatibilities Not applicable. SECTION 8: Exposure controls/personal protection 8.1 Control parameters Occupational exposure limits No occupational exposure limit values exist for any of the components listed in Section 3 of this Safety Data Sheet. 8.2. Exposure controls 8.2.1. Engineering controls Not applicable. 8.2.2. Personal protective equipment (PPE) Eye/face protection Eye protection not required. Skin/hand protection No protective gloves required. Respiratory protection Respiratory protection is not required. SECTION 9: Physical and chemical properties 9.1. Information on basic physical and chemical properties Physical state Solid. Specific Physical Form: Glass ampule with test strip and media, enclosed in a covered plastic vial. Appearance/Odour Glass ampule with test strip and media, enclosed in a covered plastic vial. Odour threshold Not applicable. pH ± 7.5 [Details:(applies to media)] Melting point/Freezing point No data available. Boiling point/Initial boiling point/Boiling range ± 100 ºC [Details:(applies to media)] Flash point Not applicable. Evaporation rate No data available. Flammability (solid, gas) Not classified Flammable Limits(LEL) Not applicable. Flammable Limits(UEL) Not applicable. Vapour pressure Not applicable. Vapour density Not applicable. Density 1 g/ml Relative density ± 1 [Ref Std_WATER=1] Water solubility Negligible Solubility- non-water Not applicable. Partition coefficient: n-octanol/water No data available. Autoignition temperature Not applicable. Decomposition temperature Not applicable. Viscosity No data available. Volatile organic compounds (VOC) Not applicable. Percent volatile ± 0 % VOC less H2O & exempt solvents No data available. SECTION 10: Stability and reactivity 10.1 Reactivity This material is considered to be non reactive under normal use conditions 10.2 Chemical stability Stable. 10.3. Conditions to avoid None known. 10.4. Possibility of hazardous reactions Hazardous polymerisation will not occur. 10.5 Incompatible materials None known. 10.6 Hazardous decomposition products Substance Condition Not applicable. Not specified. Under recommended usage conditions, hazardous decomposition products are not expected. Hazardous decomposition products may occur as a result of oxidation, heating, or reaction with another material. SECTION 11: Toxicological information The information below may not be consistent with the material classification in Section 2 if specific ingredient classifications are mandated by a competent authority. In addition, toxicological data on ingredients may not be reflected in the material classification and/or the signs and symptoms of exposure, because an ingredient may be present below the threshold for labelling, an ingredient may not be available for exposure, or the data may not be relevant to the material as a whole. 11.1 Information on Toxicological effects Signs and Symptoms of Exposure Based on test data and/or information on the components, this material may produce the following health effects: Inhalation No health effects are expected. Skin contact No health effects are expected. Eye contact No health effects are expected. Ingestion No health effects are expected. No known health effects. Additional information: This product, when used under reasonable conditions and in accordance with the 3M directions for use, should not present a health hazard. However, use or processing of the product in a manner not in accordance with the product's directions for use may affect the performance of the product and may present potential health and safety hazards. Toxicological Data If a component is disclosed in section 3 but does not appear in a table below, either no data are available for that endpoint or the data are not sufficient for classification. Acute Toxicity Name Route Species Value Overall product Ingestion No data available; calculated ATE >5,000 mg/kg
ATE = acute toxicity estimate
Skin Corrosion/Irritation
For the component/components, either no data are currently available or the data are not sufficient for classification.
Serious Eye Damage/Irritation
For the component/components, either no data are currently available or the data are not sufficient for classification.
Skin Sensitisation
For the component/components, either no data are currently available or the data are not sufficient for classification.
Respiratory Sensitisation
For the component/components, either no data are currently available or the data are not sufficient for classification.
Germ Cell Mutagenicity
For the component/components, either no data are currently available or the data are not sufficient for classification.
Carcinogenicity
For the component/components, either no data are currently available or the data are not sufficient for classification.
Reproductive Toxicity
Reproductive and/or Developmental Effects
For the component/components, either no data are currently available or the data are not sufficient for classification.
Target Organ(s)
Specific Target Organ Toxicity – single exposure
For the component/components, either no data are currently available or the data are not sufficient for classification.
Specific Target Organ Toxicity – repeated exposure
For the component/components, either no data are currently available or the data are not sufficient for classification.
Aspiration Hazard
For the component/components, either no data are currently available or the data are not sufficient for classification.
Exposure Levels
Refer Section 8.1 Control Parameters of this Safety Data Sheet.
Interactive Effects Not determined.
SECTION 12: Ecological information
The information below may not be consistent with the material classification in Section 2 if specific ingredient classifications are mandated by a competent authority. Additional information leading to material classification in Section 2 is available upon request. In addition, environmental fate and effects data on ingredients may not be reflected in this section because an ingredient is present below the threshold for labelling, an ingredient is not expected to be available for exposure, or the data is considered not relevant to the material as a whole. 12.1. Toxicity
Acute aquatic hazard:
Not acutely toxic to aquatic life by GHS criteria.
Chronic aquatic hazard:
Not chronically toxic to aquatic life by GHS criteria.
No product test data available.
No component test data available.
12.2. Persistence and degradability
12.3 : Bioaccumulative potential
12.4. Mobility in soil
Please contact manufacturer for more details
12.5 Other adverse effects No information available.
SECTION 13: Disposal considerations
13.1. Disposal methods
Dispose of contents/ container in accordance with the local/regional/national/international regulations.
Dispose of waste product in a permitted industrial waste facility. As a disposal alternative, incinerate in a permitted waste incineration facility.
SECTION 14: Transport Information
Australian Dangerous Goods Code (ADG) – Road/Rail Transport UN No.: Not applicable.
Proper shipping name: Not applicable.
Class/Division: Not applicable.
Sub Risk: Not applicable.
Packing Group: Not applicable.
Hazchem Code: Not applicable IERG: Not applicable.
International Air Transport Association (IATA) – Air Transport UN No.: Not applicable.
Proper shipping name: Not applicable.
Class/Division: Not applicable.
Sub Risk: Not applicable.
Packing Group: Not applicable.
International Maritime Dangerous Goods Code (IMDG)- Marine Transport UN No.: Not applicable.
Proper shipping name: Not applicable.
Class/Division: Not applicable.
Sub Risk: Not applicable.
Packing Group: Not applicable.
Marine Pollutant: Not applicable.
SECTION 15: Regulatory information
15.1. Safety, health and environmental regulations/legislation specific for the substance or mixture
Australian Inventory Status:
This product is regulated by the Therapeutics Goods Administration and is exempt from compliance with the Industrial Chemicals (Notification and Assessment) Act 1989 as amended.
Poison Schedule:This product has not been assessed for poisons scheduling as the product is intended for industrial and professional use only.
SECTION 16: Other information
Revision information:
Conversion to GHS format SDS.
DISCLAIMER: The information on this Safety Data Sheet is based on our experience and is correct to the best of our knowledge at the date of publication, but we do not accept any liability for any loss, damage or injury resulting from its use (except as required by law). The information may not be valid for any use not referred to in this Safety Data Sheet or use of the product in combination with other materials. For these reasons, it is important that customers carry out their own test to satisfy themselves as to the suitability of the product for their own intended applications.
Greenguard ® is a United States based program. The ‘Low VOC’ reference related to United States Federal and State regulations exemptions for some solvents.
3M Australia SDSs are available at www.3m.com.au

Product Categories: STERILIZATION, ATTEST BIOLOGICAL INDICATORS STANDARD reading, ATTEST - biological vial indicators, containing bacterial spores and medium (reading after 24 or 48 hours)

Sales unit: package

Quantity in pcs in package: 25

Min quantity to order: 25

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Product Categories: STERILIZATION, ATTEST BIOLOGICAL INDICATORS STANDARD reading, ATTEST – biological vial indicators, containing bacterial spores and medium (reading after 24 or 48 hours)

Sales unit: package

Quantity in pcs in package: 25

Min quantity to order: 25

Print Friendly, PDF & Email

en English
X
Select your currency
PLN Polish złoty
EUR Euro